Corrosion Cause Identify

Corrosion cause identification: All the following corrosion have ONE CAUSE ONLY; That is electrical current, we name Stray Current.  Important: Stray Current can only be battery or regulator sourced and is DC.  Mains or shore power (AC) CANNOT combine with DC.

Language translater page bottomLanguage translator page bottom

20-year guarantee, warranty and diagnostic support,

20 year guarantee manufacturers faults

Important: stray current is the ONLY cause of electrolysis corrosion.  Click link for external proof.  Stray current flows from ALL metal on your boat through contact to the sea, and the air, to the Earth (we stand on). Not the mains power supply, Earth.  DC cannot be part of AC or shore power – Trying to combine the two would create a massive explosion.

Often several causes are in parallel.  So, ordinary fault diagnosis must fail. SeaBis Master System 100% succeeds 100% of the time.  Click for multiple battery banks here.

SeaBis identifies the battery side, negative or positive, causing the stray current. So, halving your work.

In conclusion: The SeaBis Master System will prevent ALL CAUSE/s permanently.

Samples of stray current, electrolysis, corrosion and PREVENTING the CAUSE/s:

Marine corrosion prevention

First, a fibreglass hull insulates the hull, so the stray current from the engine is conducted to the sea via the propeller. The engine and gearbox internals will be corroded as the propeller.
Prevention of engine stray current:  Use SeaBis Master system.  Contact us seabisbg@gmail.com

Hull dissolves causing paint to lift.

Also: a metal hull is dissolved by stray current so the paint lifts.  The source of stray current must, first, be prevented by the SeaBis Master System, then paint will remain as applied.
A faulty antenna caused the stray current. Prevention: contact us then replace the antenna.

Hull corrosion-from inside hull.

Next: An aluminium hull is dissolved. The cause was an isolating switch that was not operated.  There was no SeaBis Master System onboard, so no SeaBis red flashing light to warn of the isolating switch not operated.
Prevention: install SeaBis Master System.

Outboard leg corrodes

Another outboard engine is dissolved. Another isolating switch that was not operated.  Again, there was no SeaBis Master System onboard, so no SeaBis red flashing light to warn of the isolating switch not operated.
Prevention:  Install SeaBis Master System.

Marine corrosion prevention
Before SeaBis

First: Yacht Utopia II hull, on the slip. Multiple manufacturing faults caused the hull to pass the battery – DC,  negative current through the hull then the water to the Earth (we stand on).  So, the hull dissolved to the Earth, so the antifouling (coating) had no metal to secure to so lifted. In addition:

After SeaBis. Antifouling works as designed.
After SeaBis

Second and finally: Yacht Utopia II hull, after a year, submerged.  The CAUSES of stray current electrolysis are prevented.  The antifouling remains as new.
All stray current prevented by installing SeaBis Master System.

Post dissolved
After SeaBis

Finally: Proof stray current with electrolysis capability can flow through the air.
Prevention: Install SeaBis Master System, then no stray current so no electrolysis corrosion.

Corrosion prevention system
Secured By miniOrange